One chip, two boards, one book.
The UNO R3 and the Nano V3.0 carry the same ATmega328P at 16 MHz and the same CH340C. Everything that is about the chip and the Arduino IDE is here, written once; pick your board and the text, the settings and the drawings follow it.
What is only true of one board, its parts, its pin strips and its power, is in that board’s own handbook: UNO R3 USB-C and Nano V3.0 USB-C.
Install, then the first upload
5 articlesThe Arduino IDE, the CH340 driver, the Tools menu rows, and what a good upload looks like.
How a sketch is written
6 articlessetup() and loop(), printing to the Serial Monitor, the types that overflow, and time without delay().
Libraries
4 articlesWhat a library is, the three ways to install one, and what to do when the IDE finds two.
Digital pins
6 articlesDrive a pin, read a pin, the pull-up that ends a floating input, bounce, and interrupts.
Analogue input
4 articlesanalogRead's 1024 steps, the reference that sets them, the supply the board can measure, and map().
PWM
4 articlesA pin that is only ever on or off, made to look half on: duty cycle, the six ~ pins, fades and the timers they share.
Talking to other parts
3 articlesSerial on D0 and D1, I2C on A4 and A5, and SPI on 10 to 13 and the ICSP header.
A build
1 articleOne build on the board alone that uses most of the book: digital in and out, an interrupt, millis() and EEPROM.