The four ESP32-S3 bases
One ESP32-S3, one display plug on the same GPIOs, four ways to wire to it: pins, push-in terminals, screw terminals, or pins with an LED on every GPIO.
See this board 36one per GPIOESP32-S3 N16R8 PinPulse Shield, 36 GPIO LEDsRows a side: 2 × 22 pins and sockets
See this board 28ESP32-S3 Expansion Base (2.54 mm)Strips: 4 × 20 pins at 2.54 mm
See this board 24ESP32-S3 Pluggable Terminal BaseTerminals: 2 × 12 at 3.5 mm
You have this26ESP32-S3 Screw Terminal BaseTerminals: 2 × 15 at 3.5 mmQuestions people ask first
Which way round does the ESP32-S3 go on the base?
Its USB sockets go over the two boxes printed USB, at the bottom of the base, with the antenna end at the top under the display connector.
Nothing stops the other way: the two sockets are identical, so the board seats just as firmly end for end. Put in backwards, its 3.3 V regulator output ends up wired to ground, and the board can be damaged for good. Seat the board first and plug the USB cable in second, every time.
Where does the power for my sensors come from?
The base has no regulator, no battery connector and no power input. It is powered through the ESP32-S3's own USB sockets, and every power way on it is one of that board's pins carried out.
The 3V3 ways are the output of the regulator on the ESP32-S3. The 5V ways are the board's 5V pin: about 4.6 V with a USB cable plugged in, and nothing without one. Nothing on the way is switched, fused or filtered.
Can I run a motor, relay or LED strip from the base?
Not from its power ways. Motors, relays, servos and long LED strips need their own supply, with its ground joined to a GND way on the base, because the ESP32-S3's regulator is small and is also running your sketch.
Small sensors and a display can take 3V3 and ground from the base. No current rating is quoted for the ways, because none has been checked.
How many GPIOs does the Screw Terminal Base bring out?
26 of the ESP32-S3's GPIOs, once each, on two 15-way screw terminal blocks, with 3V3 on the left block and 5V on the right. Ten GPIOs do not come out.
The native USB pins (GPIO 19 and 20) are on the right block: a wire on either one shares the USB lines with the computer, so leave them alone unless the sketch is not using native USB.
My sensor resets when Wi-Fi connects. Why?
The ESP32-S3's datasheet gives about 340 mA at the peak while Wi-Fi transmits, and a USB port is meant to supply 500 mA in all. The burst lasts a moment and the 3.3 V rail dips with it; a sensor that resets when Wi-Fi connects is usually seeing that dip.
Put a capacitor of about 100 uF between 3V3 and ground, close to the sensor. It holds the rail up for the length of the burst. The base has none of its own, because it has no power parts at all.
Product questions
See what other owners have asked, and read their solutions.
ESP32-S3 Screw Terminal Base
Loading discussions…
Email us or reply to your order, and quote s3screw — that identifies the product. If something is missing from the bag, your order is the record of what shipped.
Point a phone camera at the code and this page opens there. It is the same address as the one printed on your box, so it is also what to show someone you are passing the board to.