
Boards in 3D
The real PCB, turned over and clicked on. Pin order, hole positions and everything each pin can do are read from that board’s own net list and 3D model, so the hole you click is the hole on your desk — not an averaged diagram of boards that look similar.






















































































Reading rather than turning
Every board here has written pages as well. For a dev board that is the same pins as a table you can search, plus the ones that are already spoken for and the ones that stop the board booting; for a module, the handbook about it.
- ESP32-S3 PinPulse Shield pinout
- ESP32-S3 Expansion Base pinout
- ESP32-S3 Screw Terminal Base pinout
- ESP32-S3 Pluggable Terminal Base pinout
- ESP32-S3 pinout
- ESP32 Gold Edition pinout
- ESP32-C3 OLED Board and Its Three Bases: Expansion, Pluggable Terminal and Screw Terminal
- Nano V3.0 USB-C and PinPulse Shield: Seating the Nano, the LEDs and the First Sketch
- SD and microSD Card Readers for ESP32: SPI, 1-bit and 4-bit
- XL LED
- RGB LED
- Traffic Light
- Push Button
- Latching Button
- Rotary Encoder
- Disc Potentiometer
- Rotary Potentiometer
- Voltmeter
- NTC Thermistor
- IR Receiver
- Collision Sensor
- Hall Effect Sensor
- 4-Direction Tilt Sensor
- Ambient Light Sensor
- Slim Joystick
- Dual Axis Joystick
- Analog Microphone
- Knock Sensor
- Analog to Digital Signal
- Vibration Motor
- EEPROM Memory
- Active Buzzer
- Passive Buzzer
- DHT11 Temperature and Humidity Sensor
- DHT22 Temperature and Humidity Sensor
- Reed Switch
- Door Sensor
- Infrared Transmitter
- Dual Bright LEDs
- Infrared Receiver
- Steam Sensor
- Linear Hall Effect Sensor
- Matrix Keypad with I2C Adapter (4x4, PCF8574)
- 1.8-inch TFT Display
- SPI TFT LCD Display Boards, 0.96 to 3.5 inch
- Mechanical Key and LED
- Five-Direction Joystick
- Piezo-Ceramic Sensor
- Infrared Speed Sensor
- Tilt Sensor
- LM75 Temperature Sensor
- TTP223 Touch Sensor
- Reflective Optical Sensor
- Ultrasonic Distance Sensor
- TM1637 4-Digit Display (0.56 inch)
- 8x8 LED Matrix
- 74HC595 Segment LED
- 4″ 7-Segment LED Display with 74HC595
- WS2812 RGB LED Bar
- DRV8833 Dual Motor Driver
- USB-C Breakout Board with 5.1 kΩ CC Resistors
- Breadboard Power Adapters: Standard 5 V / 3.3 V, Step-Down and Booster
- RS485 Transceiver Boards: MAX485 for 5 V and MAX3485 for 3.3 V
- CAN Bus
- I2S Amplifier
- PDM Microphone
- I2S DAC
- INA219 Current Monitor
- SHT31 Temperature and Humidity Sensor
- 3-Axis Accelerometer
- Logic Level Converter
- HotSwap Arcade Kit: Buttons, Joystick and Coin Acceptor for ESP32-S3, Nano, Pico and Zero 2 W
- PCA9685 16-Channel Servo Driver: Sixteen Servos on Two I²C Wires